Icom IC-440N - Receiving Calls

38
8
SELCALL (Selective Calling)
Receiving ■
Receiving an individual call D
When receiving a RX code (default setting); q
• Beeps sound.
• The received code channel name is displayed, if programmed.
• “ë” and the displayed channel name* blink, and the Selcall
mute is released when the Quiet mode is activated.
* “ë” blinks and the channel number appears when the channel
name is not programmed.
While holding down w [PTT], speak into the microphone at a
normal voice level.
Blink
NOTE: When the ID decode function is turned ON, the re-
ceived ID code is displayed instead of the channel name,
and memorised into the transceiver. The function can be
turned ON using the CS-440N
CLONING SOFTWARE.
• RX code means the Receiving SelCall code. A maximum
of 8 individual call channels can be pre-programmed into
the transceiver using the CS-440N.
• You can set the transceiver’s mode when receiving an
individual call using the CS-440N. See the help fi le for
setting details.
Recalling a memorised received ID code D
Push q
F
SET
(Function) to enter the Function mode, then hold
down
O࡮G࡮P
RS
(ID-MR) for 2 seconds to display the memorised
received ID code.
Push w
or to select the desired received ID code.
Push [PTT] to transmit the code on the selected channel. e
Receiving a Group call D
When receiving a Group call (default setting); q
• “PiPi” beep sounds.
• “ë” and “GROUP” blink, and the SelCall mute is released when
the Quiet mode is activated.
While holding down w [PTT], speak into the microphone at a
normal voice level.
Blink
You can set the transceiver’s mode when receiving a
Group call with the CS-440N. See the help fi le for more
information.