Icom IC-440N - Quiet Mode Operation; Stun Mode

39
8
SELCALL (Selective Calling)
8
Quiet mode ■
When Quiet mode is turned ON, the SelCall mute is activated
and allows Silent operation until receiving a SelCall.
➥ Push
F
SET
(Function) to enter the Function mode, then push
O࡮G࡮P
RS
(Quiet) to toggle the Quiet mode ON and OFF.
• “Q” appears when the Quiet mode is in use.
Appears
To monitor the channel:
➥ Push
MONI
TSQL
(Monitor) to release the mute (audio is heard.)
• “ ” blinks when the Monitor function is in use.
Blinks
To enable SelCall mute:
When “
” blinks, push
MONI
TSQL
(Monitor) to mute the channel.
“ ” disappears.
NOTE: The Unmute mode may automatically return to the
Mute mode after a specifi ed time period, depending on the
pre-setting.
Stun ■
When the transceiver is in the Stun mode, it will request a
password at power ON. This password is the same as the
Power ON function password. Once the password has been
input, the transceiver will not prompt for it to be input again.
Cloning and use of the transceiver is disabled after the kill
ID is received. By activating the clone write mode, the trans-
ceiver can be returned to a usable mode.
(The internal data cannot be accessed by the cloning read
mode.)