44
9
OTHER FUNCTIONS
All reset ■
The function display may occasionally display erroneous in-
formation. This may be caused externally by static electricity
or by other factors. If this problem occurs, turn OFF the pow-
er. After a few seconds, turn ON the power. If the problem
persists, perform the following procedure.
IMPORTANT!:
Resetting the transceiver sets the Set mode values to their
default values.
Holding down
CH
SQL
,
LOW
,
MONI
TSQL
and for 2 seconds will reset
the CPU.
• “AL RESET” appears on the function display when the transceiver
is reset.
To Next Page
Loading...
