24
4
SET MODE
Scan resume timer D
The Scan Resume mode can be set as a pause (P5) or timer
scan (15/10/5). When signal disappears, scan resumes after
5 seconds regardless of the setting.
15/10/5 : Scan pauses for 15, 10 or 5 seconds when a signal
is detected, then resumes.
P5 : Scan pauses until the signal disappears and then
resumes after 5 seconds (Default and recommend-
ed setting.)
Scan resume timer
P5 (default)
10 second setting
Scan restart function D
This function starts the scan after the transmission is per-
formed during the scan and after 10 seconds.
Scan restart timer
OFF (default)
Scan restart timer ON
Roger Beep D
This function emits a beep on the communication party to
inform the termination of the transmission.
Roger beep OFF (default) Roger beep ON
To Next Page
Loading...
