Icom IC-440N - Page 43

37
8
SELCALL (Selective Calling)
8
t Push or to select the desired code.
• Select “✱” when Group code is set.
y Push
SCAN
TAG
(TX Code CH) to set the selected digit.
• The editable digit to right is automatically selected to be se-
lected.
u Repeat steps t and y to input all allowed digits.
i After setting the last digit, push
SCAN
TAG
(TX Code CH) to set the
code and return to the TX code channel selection mode.
o Push [PTT] to transmit on the selected TX code channel,
or push
SCAN
TAG
(TX Code CH) to set the selected TX code
channel and return to the standby mode.
Appears
Transmitting
NOTE: The TX code editable digit can only be set or
changed with the CS-440N
CLONING SOFTWARE.
✓ CONVENIENT!
Push
F
SET
(Function) to enter the Function mode, then push
and hold
SCAN
TAG
(Call) for 2 seconds to transmit the selected
channel’s TX code.
Appears
Transmitting