Icom IC-7410

108
CONTROL COMMAND
1
2
3
4
5
6
7
8
9
10
11
12
15
16
17
19
20
21
14
18
14
13
s$ATAMODEWITHlLTERWIDTHSETTING
Command : 1A 06
XXXX
qw
00: Data mode OFF
01: FIL1
02: FIL2
03: FIL3
00: Data mode OFF
01: Data mode ON
s2EPEATERTONETONESQUELCHFREQUENCY
SETTING
Command : 1B 00, 1B 01
q* ew
00
XXXX
0 (fixed) 0 (fixed) 100 Hz digit 10 kHz digit 1 Hz digit 0.1 Hz digit
*Not necessary when setting a frequency.
q, w Memory channel number
0001–0099 : Memory channel 01 to 99
0100 : Programmed scan edge P1
0101 : Programmed scan edge P2
e Split and Select memory settings
XX
e
0: Select memory OFF
1: Select memory ON
0: Split OFF
1: Split ON
When the program channel is selected, both settings
should be “0.”
r–i Operating frequency setting
3EEhs/PERATINGFREQUENCYvP
o, !0 Operating mode setting
3EEhs/PERATINGMODEvP
!1 $ATAMODESETTING
1 byte data (XX)
00: Data mode OFF
01: Data mode ON
!2 Tone setting
XX
!2
0: OFF, 1: Tone
2: TSQL
0 (fixed)
!3–!5 Repeater tone frequency setting
!6–!8 Tone squelch frequency setting
3EEhs2EPEATERTONETONESQUELCHFREQUENCYSETTINGv
as described above.
!9–@7 Memory name setting
9 characters (fixed)
3EEhs#HARACTERCODESETTINGvP
‘1A 00’ command with the format as below clears the
data of the selected memory channel.
q, w : Memory channel 0 to 99
e : FF
r or later : None
s-EMORYCONTENTSETTING
Command : 1A 00
X
er–io, !0 !1 !2 !3–!5 !9–@7!6–!8
XXX……XXXXXXXXXXXXXXXXXX XXXX XXXX ……XX XX
q, w
r−!8:
r−!8
r−!8.
......
Are programmed in the same manner as
When the split setting is ON, these settings are the matching transmit settings.
Even when the split setting is OFF, these settings are still necessay.
Be sure the settings are compatible with the specifications of the IC-7410.