Icom IC-7410

73
MEMORY OPERATION
7
N-EMORYNAMEPROGRAMMING
All Memory channels, including scan edges channels,
can be assigned an alphanumeric names of up to nine
characters each.
;%8!-0,%= Programming a memory name into
Memory channel 99.
q Push [VFO/MEMO] to select the Memory mode.
w Push [Y] or [Z] to select Memory channel 99.
e Push [MENU] one or more times to display the “M2”
screen (Menu 2).
r Push [MEM](F-2) to display the “MEM” screen
(Memory Menu).
t Push [EDT](F-1) to display the “EDT” screen (Mem-
ory Name Edit).
 s!CURSORAPPEARSANDBLINKS
 s)FTHECHANNELYOUSELECTISABLANKCHANNELANERROR
beep sounds.
y Push [F-1] one or more times to select the desired
character type.
 s3EETHEh#HARACTERTABLELISTvBELOW
u Rotate [DIAL] to select the first character to input.
s7HENINPUTTINGNUMBERSANDADECIMALPOINTPUSHTHE
appropriate keypad key.
 s0USH;$%,=&TODELETETHESELECTEDCHARACTER
 s0USH;30#=&TOINPUTASPACE
 s!NERRORBEEPSOUNDSIFYOUTRYTOPROGRAMMORETHAN
nine characters. If you want to reprogram the name,
push [Ω](F-2) or [≈](F-3)
to select any undesired char-
acter, then push [DEL](F-4) to delete it.
i Push [Ω](F-2) to move the cursor backward, or push
[≈](F-3) to move the cursor forward.
o Repeat steps y to i to program a memory name
of up to 9 characters.
!0 Push [MENU] to save the name, and return to the
“MEM” screen.
!1 Push [MENU] again to return to the “M2” screen.
#HARACTERTABLELIST
#HARACTER
type
3ELECTABLECHARACTERS
ABC A to Z
abc a to z
etc
<" ’ ` ^ + – 1⁄ . , : ; = < > ( ) [ ] { }
¦ _ ¯ @
[][] Keypad
[DEL][F-1] [SPC]
[DIAL]
s7HENPROGRAMINGAMEMORYNAME
abc  DEL SPC
EDT
DX spot
Character type Cursor
Input a space
Delete a character
Move cursor forwards
Move cursor backwards
Select character type
;%8!-0,%=Programming “DX spot” into Memory
channel 99.
[VFO/MEMO] [MEM] [EDT]
[MENU]
[] []
SCAN MEM SWR TCON VSC
M2
EDT ( ) SEL
MEM
14.19500 USB
ABC  DEL SPC
EDT