Icom IC-7410

5
53
FUNCTIONS FOR RECEIVE
N2)4FUNCTION
The RIT (Receive Increment Tuning) function com-
pensates for off-frequency operation of the received
station.
The function shifts the receive frequency up to
±9.99 kHz in 10 Hz steps*, without changing the trans-
mit frequency.
* The [RIT/∂TX] control tunes in 1 Hz steps when the operat-
ing frequency readout is set to the 1 Hz step readout.
q Push [RIT] to turn ON the RIT function.
sh2)4vANDTHEFREQUENCYSHIFTAPPEARWHENTHISFUNCTION
is ON.
w Rotate the [RIT/∂TX] control.
 s(OLDDOWN;#,%!2=FORSECONDTORESETTHE2)4FRE-
quency.
 s0USH;#,%!2=MOMENTARILYTORESETTHE2)4FREQUENCY
when the “Quick RIT Clear” item is set to “ON” in the Set
mode. (p. 88)
 s(OLDDOWN;2)4=FORSECONDTOADDTHEFREQUENCYSHIFT
to the operating frequency, if desired.
e To cancel the RIT function, push [RIT] again.
 sh2)4vANDTHEFREQUENCYSHIFTDISAPPEAR
D2)4-ONITORFUNCTION
When the RIT function is ON, holding down [XFC] al-
lows you to listen to the displayed frequency (RIT is
temporarily cancelled).
Appear
[RIT] [CLEAR]
[RIT/∂TX]
AGC TBW SCP
M1
[XFC]