Icom IC-7410

85
SET MODE
10
N3ETMODEDESCRIPTION
The Set mode is used for programming infrequently
changed values or functions.
D 4HE3ETMODESETTINGS
q Hold down [MENU] for 1 second to enter the Set
mode.
w Push [Y](F-1) or [Z](F-2) to select the desired
item.
e Rotate [DIAL] to select the desired option.
s(OLDDOWN;&=FORSECONDTORESETTOTHEDEFAULTSET-
ting, if desired.
r Push [MENU] to save, and exit the Set mode.
Select the item
Reset to the default
setting
[]
[MENU] [F-3] [DIAL]
[][]
Ù 1 Ú 50%
SET
LCD Contrast
Displays the Set mode
item name and number
Displays the option
,#$#ONTRAST1. $EFAULT
!DJUSTTHE,#$CONTRASTTOBETWEENANDIN
STEPS
,#$"ACKLIGHT2. $EFAULT
!DJUSTTHE,#$BACKLIGHTBRIGHTNESSTOBETWEEN
ANDINSTEPS
./4% Regardless of this setting, the LCD backlight
BRIGHTNESSISMAXIMUMATPOWER/.BYDE-
sign. (It is not an equipment malfunction.) Then, the
brightness level automatically returns to the ad-
justed value.
"EEP,EVEL3. $EFAULT
Adjust the confirmation and band edge beep tones
OUTPUTLEVELTOBETWEENANDINSTEPS
"EEP,EVEL,IMIT4. $EFAULT/.
Turn the confirmation and band edge beep tones out-
put level limiting ON or OFF.
When you set this item to ON, the beep tones are ad-
justed by the [AF] control until rotating the [AF] control
reaches to the specified level. Further rotation will not
increase the volume of the beep tones.
s/&&"EEPLEVELADJUSTMENTISNOTLIMITED
s/. "EEPLEVELADJUSTMENTISLIMITEDWITHTHE;!&=
control.
"EEP5. $EFAULT/.
Turn the confirmation beep ON or OFF.
Set the beep output level in
the “Beep Level” item, as
described to the left .
s/&&4HECONlRMATIONBEEPIS/&&3ILENTOPERA-
tion)
s/. 4HECONFIRMATIONBEEP SOUNDS EACHTIME A
switch is pushed.
"AND%DGE"EEP6. $EFAULT/.$EFAULT
When you tune into or out of an amateur band’s fre-
quency range, you can hear a beep tone.
)FYOUSELECTh/.5SERvORh/.5SER48vYOUCAN
program a total of 30 band edge frequencies in
the
“User band Edge” item.
You can set the beep output level in the “Beep Level”
item as described to the left .
s/&&  "ANDEDGEBEEPIS/&&
s/.$EFAULT 7HENYOUTUNEINTOOROUTOFTHE
default amateur band’s frequency
range, a beep sounds.
s/.5SER  7HENYOUTUNEINTOOROUTOFAUSER
programmed amateur band’s fre-
quency range, a beep sounds.
s/.5SER487HENYOUTUNEINTOOROUTOFAUSER
programmed amateur band’s fre-
quency range, a beep sounds.
In addition, transmission is inhibited
outside the programmed range.