81
SCANS
8
∂F (Delta Frequency) scan searches for signals within
the specified range with the displayed VFO frequency
or Memory channel frequency as the center frequency.
The frequency range is specified by the width of the
selected span.
q Push [VFO/MEMO] once or twice to select the VFO
mode or Memory mode.
w
P
ush [MENU] one or more times to display the “M2”
screen (Menu 2).
e
P
ush [SCAN](F-1) to display the “SCAN” screen.
r Rotate the [RF/SQL] control to set the squelch to
open or closed.
s4HESCANPERFORMANCEDIFFERSDEPENDINGONTHESQUELCH
setting when the scan was started. See page 76 for de-
tails.
s)FTHE;2&31,=CONTROLFUNCTIONISSETTOh!54/vTHE
squelch is always open in the SSB, CW and RTTY
modes. (pp. 2, 32, 86)
t Push [SPAN](F-4) one or more times to select the
desired ∂F span width.
sÒ K(Z Ò K(Z Ò K(Z Ò K(Z Ò K(Z
±500 kHz and ±1 MHz are selectable.
y Set the center frequency of the ∂F scan.
s)NTHE6&/MODEPUSHTHEKEYPADORROTATE;$)!,=TO
set the center frequency.
s)NTHEMEMORYMODEPUSH;Y] or [Z] to select the de-
sired Memory channel whose frequency will be the cen-
ter frequency.
u Push [∂F](F-2) to start or cancel the ∂F scan.
sh∂F SCAN,” the MHz and kHz decimal points blink while
scanning.
s2OTATING;$)!,=ALSOCANCELSTHESCAN
N ∂&SCANAND&INE∂&SCAN
D!BOUTTHE&INE∂&SCAN
When a signal is received during Fine ∂F scan, the
scanning tuning step is temporarily set to 10 Hz and
the scan speed decreases.
q Starta ∂F scan.
s&OLLOWSTEPSq through u as described above.
w While scanning, push [FIN](F-3) to switch the scan
function between ∂F scan and Fine ∂F scan.
sh&∂F SCAN” blinks while Fine ∂F scanning.
e Push [∂F](F-2) to cancel the scan.
s2OTATING;$)!,=ALSOCANCELSTHESCAN
While ∂F scanning
MEM
F
SPAN SE TFIN
SCAN
MEM
F
SPAN SE TFIN
SCAN
F−
F
SCAN
F
SCAN
20k
20k
While Fine ∂F scanning
[SCAN] [VFO/MEMO]
[MENU]
[F] [SPAN]
[DIAL]
[] []
Keypad
MEM
F
SPAN SE TSEL
SCAN
F
:
10k
MEM
F
SPAN SE TSEL
SCAN
F
:
20k
F
SCAN
MEM
F
SPAN SE TSEL
SCAN
20k
To Next Page
Loading...
