Icom IC-7410

80
SCANS
1
2
3
4
5
6
7
9
10
12
13
14
15
16
17
18
19
20
21
11
8
8
D3ELECT-EMORYSCAN
Select Memory scan searches for signals through
Memory channels programmed as “Sel” (Select).
./4% To start a Select Memory scan, two or more
Memory channels must be designated as Select
Memory channels.
q Start a Memory scan.
 s&OLLOWSTEPSq through t on the previous page.
w While scanning, push [SEL](F-3) to switch the scan
function between a Memory scan and a Select
Memory scan.
 sh3%,-%-/3#!.vBLINKSWHILE3ELECT-EMORYSCAN-
ning.
e Push [MEM](F-1) to cancel the scan.
 s2OTATING;$)!,=ALSOCANCELSTHESCAN
All Memory channels can be set as Select Memory
channels, except for the Scan Edge channels.
± When the “SCAN” screen is displayed, push [SEL]
(F-3), or when the “MEM” screen (Memory Menu)
is displayed, push [SEL](F-5) to set or cancel the
displayed Memory channel as a Select Memory
channel.
 sh3%,vAPPEARSWHEN THE CHANNEL ISSETAS A 3ELECT
Memory channel.
 s!N ERROR BEEP SOUNDS WHEN THE DISPLAYED -EMORY
channel is a blank channel.
 s(OLDINGDOWN;3%,=&OR;3%,=&FORSECONDDIS-
plays “SEL ALL Clear?.” Hold down [YES](F-4) to clear
all Select Memory channel settings.
MEM
∂ F
SPAN SE TSEL
SCAN
MEMO SCAN
MEM
∂ F
SPAN SE TSEL
SCAN
SEL−MEMO SCAN
MEM
 F
SPAN SE TSEL
SCAN
 F :  10k
Appears
“SCAN” screen
“MEM” screen (Memory Menu)
While Select Memory scanning
D 3ETTING#ANCELLING3ELECT-EMORYCHANNELS
EDT ( ) SEL
MEM
14.19500 USB