Icom IC-7410

79
SCANS
8
D-EMORYSCAN
A Memory scan searches for signals through Memory
channels 1 to 99.
Blank (unprogrammed) channels are skipped.
./4% To start a Memory scan, two or more Mem-
ory channels must be programmed. (p. 70)
q Push [VFO/MEMO] to select the Memory mode.
w P ush [MENU] to display the “M2” screen (Menu 2).
e P ush [SCAN](F-1) to display the “SCAN” screen.
r Rotate the [RF/SQL] control to set the squelch to
open or closed.
s4HESCANPERFORMANCEDIFFERSDEPENDINGONTHESQUELCH
setting when the scan was started. See page 76 for de-
tails.
s)FTHE;2&31,=CONTROLFUNCTIONISSETTOh!54/vTHE
squelch is always open in the SSB, CW and RTTY
modes. (pp. 2, 32, 86)
t Push [MEM](F-1) to start or cancel the Memory
scan.
s4HE-(ZANDK(ZDECIMALPOINTSANDh-%-/3#!.v
blink while scanning.
 s2OTATING;$)!,=ALSOCANCELSTHESCAN
N-EMORYSCAN-EMORYMODE
[SCAN]/[MEM] [VFO/MEMO]
[MENU][RF/SQL]
While Memory scanning
MEM
 F
SPAN SE TSEL
SCAN
 F :  10k
MEM
∂ F
SPAN SE TSEL
SCAN
MEMO SCAN