Icom IC-7410 - Page 85

78
SCANS
1
2
3
4
5
6
7
9
10
12
13
14
15
16
17
18
19
20
21
11
8
8
A programmed scan searches for signals between
Program Scan Edge channels “P1” and “P2.”
Before starting the programmed scan, scan edges
must be programmed into these channels.
Refer to “N Memory Channel programming” to pro-
gram Program Scan Edge channels. (p. 70)
If the same frequencies are programmed into the
Program Scan Edge channels, the programmed
scan will not start.
q Push [VFO/MEMO] to select the VFO mode.
w Push a mode switch to select the desired operating
mode (p. ).
 s4HEOPERATINGMODECANALSOBECHANGEDWHILESCAN-
ning.
e Push [TS] one or more times to select a tuning step.
(p. 27)
 s4HETUNINGSTEPCANALSOBECHANGEDWHILESCANNING
r P ush [MENU] once or twice to display the “M2”
screen (Menu 2).
t P ush [SCAN](F-1) to display the “SCAN” screen.
y Rotate the [RF/SQL] control to set the squelch to
open or closed.
s4HESCANPERFORMANCEDIFFERSDEPENDINGONTHESQUELCH
setting when the scan was started. See page 76 for de-
tails.
s)FTHE;2&31,=CONTROLFUNCTIONISSETTOh!54/vTHE
squelch is always open in the SSB, CW and RTTY
modes. (pp. 2, 32, 86)
u Push [PRO](F-1) to start or cancel the programmed
scan.
 s4HE-(ZANDK(ZDECIMALPOINTSANDh02/'3#!.v
blink while scanning.
 s2OTATING;$)!,=ALSOCANCELSTHESCAN
N0ROGRAMMEDSCAN&INEPROGRAMMEDSCAN6&/MODE
D!BOUTTHE&INEPROGRAMMEDSCAN
When a signal is received during Fine programmed
scan, the scanning tuning step is temporarily set to
10 Hz and the scan speed decreases.
q Start the programmed scan.
 s&OLLOWSTEPSq through u as described above.
w While scanning, push [FIN](F-3) to switch the scan
function between a programmed scan and a Fine
programmed scan.
 sh&02/'3#!.vBLINKSWHILE&INEPROGRAMMEDSCAN-
ning.
e Push [PRO](F-1) to cancel the scan.
 s2OTATING;$)!,=ALSOCANCELSTHESCAN
[SCAN]/[PRO] [VFO/MEMO] [TS]
[MENU][RF/SQL] Mode switches
While Programmed scanning
PRO
 F
SPAN SE TFIN
SCAN
 F :  10k
PRO
∂ F
SPAN SE TFIN
SCAN
PROG SCAN
PRO
∂ F
SPAN SE TFIN
SCAN
PROG SCAN
PRO
∂ F
SPAN SE TFIN
SCAN
F−PROG SCAN
While Fine programmed scanning