Icom IC-7410

19
2
INSTALLATION AND CONNECTIONS
N0OWERSUPPLYCONNECTIONS
When operating the transceiver with AC power, use a
power supply with 13.8 V DC output and a capacity of
at least 23 Amps.
Refer to the diagrams below.
#!54)/. Before connecting the DC power
cable, check the following important items.
Make sure:
s4HE;0/7%2=SWITCHIS/&&
s/UTPUTVOLTAGEOFTHEPOWERSOURCEISn6
when you use a non-Icom power supply.
s$#POWERCABLEPOLARITYISCORRECT
Red : Positive + terminal
Black : Negative _ terminal
q
w
Transceiver
PS-126
AC cable
AC outlet
To [DC 13.8V]
DC power cable
D#ONNECTINGTOTHE03$#0/7%23500,9
D#ONNECTINGTOANON)COM$#0/7%23500,9
N#ONNECTINGTOA$#POWERSUPPLY
+
_
q
w
Supplied DC power cable
AC cable
AC outlet
Transceiver
To [GND]
A DC power supply
13.8 V;
at least 23 A
Red Black
To [DC 13.8V]
To [DC 13.8V]
For European versions
Transceiver
Connect to
power supply
Ground
Ground
4ODISCONNECT
4ODISCONNECT