Icom IC-7410

72
MEMORY OPERATION
1
2
3
4
5
6
8
9
11
12
13
14
15
16
17
18
19
20
21
7
10
7
The Memory channel contents (frequency, operating
mode, etc.) can be copied to the VFO.
The copy can be performed in either the VFO mode or
the Memory mode.
D#OPYINGINTHE6&/MODE
This is useful for copying programmed contents to
a displayed VFO.
q Push [VFO/MEMO] to select the VFO mode.
w Push [Y] or [Z] to select a Memory channel num-
ber to be copied.
 sh ” appears if the selected Memory channel is a
blank channel. In this case, nothing can be copied.
e Hold down [VFO/MEMO] for 1 second to copy the
Memory channel contents into the VFO.
 s4HREEBEEPSSOUNDWHENTHECOPYISCOMPLETE
D#OPYINGINTHE-EMORYMODE
This is useful for copying the Memory channel con-
tents while operating in the Memory mode.
When you have changed the displayed frequency,
operating mode, etc. in the selected Memory chan-
nel:
s$ISPLAYEDdata is copied.
s0ROGRAMMEDcontents in the Memory channel are
not copied, but remain in only the Memory chan-
nel.
q Push [VFO/MEMO] to select the Memory mode.
w Push [Y] or [Z] to select a Memory channel to be
copied.
 sh ” appears if the selected Memory channel is a
blank channel. In this case, select another channel.
 s3ETTHEFREQUENCYOROPERATINGMODEIFREQUIRED
e Hold down [VFO/MEMO] for 1 second to copy the
Memory channel contents into the VFO.
 s4HREEBEEPSSOUNDWHENTHECOPYISCOMPLETE
r Push [VFO/MEMO] to select the VFO mode.
[VFO/MEMO]
[] []
N-EMORYCONTENTSCOPYING
While in the Memory mode
Hold down
Push
While in the VFO mode
Hold down
The Memory channel contents are copied
The Memory channel contents are copied