Icom IC-7410 - Page 33

26
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
N&REQUENCYSETTING
You can select the transceiver’s frequency by using
[DIAL], or you can enter it using the keypad.
D4UNINGWITH;$)!,=
q Select the desired frequency band.
s0USHABANDKEYnTIMES4HREEDIFFERENTFREQUENCIES
on each frequency band can be selected with the band
key. (See the previous page “Using the band stacking
registers.”)
s4HEDEFAULTTUNINGSTEPDIFFERSDEPENDINGONTHEOPER-
ating mode.
SSB/CW/RTTY : 10 Hz
AM : 1 kHz (“Z” is displayed)
FM : 10 kHz (“Z” is displayed)
w Rotate [DIAL] to set the desired frequency.
If the Dial Lock function is ON, “ ” is displayed,
and [DIAL] does not function.
In this case, push [LOCK] to turn OFF the Dial Lock
function. (p. 61)
D$IRECTFREQUENCYENTRYWITHTHEKEYPAD
The transceiver has a keypad for direct frequency
entry, as described below.
q Push [F-INP ENT] to enter frequencies with the
keypad.
 s!LLFREQUENCYDIGITSDISAPPEAR
w Push the numeric keys to input the desired fre-
quency.
s0USH;'%.%s=TOINPUTAhvDECIMALPOINTBETWEENTHE
MHz digits and kHz digits.
e Push [F-INP ENT] to set the input frequency.
s4OCANCELTHEINPUTPUSHANYKEYSUCHAS;-7=OR
[M-CLR], before pushing [F-INP ENT].
Keypad
[EXAMPLE]
14.025 MHz
18.0725 MHz
K(Z
5.100 MHz
7.000 MHz
21.280 MHz ¶ 21.245 MHz
Band keys
[DIAL]