Icom IC-7410 - Page 48

41
4
RECEIVE AND TRANSMIT
N Electronic keyer functions (continued)
D#ONTESTNUMBER3ETMODE
This mode is used to set the contest number and count
up trigger, etc.
s3ETTINGCONTENTS
q In the CW mode, p ush [MENU] to display the “M1”
screen (Menu 1).
w Push [KEY](F-4) to display the “KEY” screen (Mem-
ory Keyer).
e Push [001](F-4) to enter the Contest Number Set
mode.
r Push [Y](F-1) or [Z](F-2) to select the desired
item.
t Rotate [DIAL] to select the desired option.
s(OLDDOWN;&=FORSECONDTORESETTOTHEDEFAULTSET-
ting, if desired.
y Push [MENU] to save, and return to the “KEY”
screen.
u Push [MENU] again to return to the “M1” screen.
.UMBER3TYLE1. $EFAULT.ORMAL
This item sets the numbering system used for contest
numbers— normal or short morse numbers.
Short morse numbers are also referred to as “cut”
numbers.
s.ORMAL $OESNOTUSESHORTMORSENUMBERS
sANO : Sets 1 as A, 9 as N and 0 as O.
sANT : Sets 1 as A, 9 as N and 0 as T.
s NO : Sets 9 as N and 0 as O.
s NT : Sets 9 as N and 0 as T.
#OUNT5P4RIGGER2. $EFAULT-
Set the count-up trigger to one of four memory slots
for the contest number exchange. The count-up trigger
allows the contest number to automatically advance
after each complete serial number exchange is sent.
s---OR-CANBESET
0RESENT.UMBER3. $EFAULT
This item shows the current number for the count-up
trigger channel set above.
s2OTATE;$)!,=TOCHANGETHENUMBERORHOLDDOWN
[F-3](CLR) for 1 second to reset the current number
to 001.
 1  Normal
001
Number Style
Select the item Reset to the default
setting