Icom IC-7410 - Page 55

48
4
RECEIVE AND TRANSMIT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
D24493ETMODE
The RTTY Set mode is used to set the mark and shift
frequencies, keying type, decode USOS function,
RTTY decoder new line code and the number of de-
code screen display lines.
s3ETTINGCONTENTS
q In the RTTY mode, p ush [MENU] to display the “M1”
screen (Menu 1).
w Push [RTTY](F-4) to display the “RTTY” screen.
e Push [SET](F-5) to enter the RTTY Set mode.
r Push [Y](F-1) or [Z](F-2) to select the desired
item.
t Rotate [DIAL] to select the desired option.
s(OLDDOWN;&=FORSECONDTORESETTOTHEDEFAULTSET-
ting, if desired.
y Push [MENU] to save, and return to the “RTTY”
screen.
u
Push [MENU] again to return to the “M1” screen.
2449-ARK&REQ1. $EFAULT
Select the RTTY mark frequency.
sAND(ZARESELECTABLE
24493HIFT7IDTH2. $EFAULT
Select the RTTY frequency shift.
sAND(ZARESELECTABLE
2449+EYING0OL3. $EFAULT./2-!,
Select normal or reverse keying polarity.
s./2-!, +EYOPENCLOSE-ARK3PACE
s2%6%23%+EYOPENCLOSE3PACE-ARK
$ECODE53/34. $EFAULT/.
Turn the USOS (UnShift On Space) function ON or
OFF. This function decodes a letter code after receiv-
ing a “space.”
s/&&$ECODESASACHARACTERCODE
s/. $ECODESASALETTERCODE
$ECODE.EW,INE5. $EFAULT#2,&#2,&
Select the internal RTTY decoder new line code.
CR: Carriage Return, LF: Line Feed
s#2,&#2,&-AKESANEWLINEWITHANYCODE
s#2,&  -AKES A NEW LINE WITH ONLY THE
CR+LF code.
$ECODE3CREEN6. $EFAULTLINE
Set the decoder screen display mode to 2 or 3 lines.
 1  2125
SET
RTTY Mark Freq
Select the item Reset to the default
setting