Icom IC-7410

70
MEMORY OPERATION
1
2
3
4
5
6
8
9
11
12
13
14
15
16
17
18
19
20
21
7
10
7
Memory channels can be programmed in either the
VFO mode or the Memory mode.
D0ROGRAMMINGINTHE6&/MODE
q Push [VFO/MEMO] to select the VFO mode.
w Set the frequency, operating mode, and other data
into both VFO A and VFO B.
e Push [Y] or [Z] to select a Memory channel num-
ber to be programmed.
sh ” appears if the selected Memory channel is a
blank channel.
r Hold down [MW] for 1 second to program the con-
tents into the Memory channel.
s4HREEBEEPSSOUNDWHENTHEmemory programming is
complete.
D0ROGRAMMINGINTHE-EMORYMODE
q Push [VFO/MEMO] to select the Memory mode.
w Push [Y] or [Z] to select a Memory channel to be
programmed.
s4HECONTENTSOFTHE-EMORYCHANNELAPPEARINTHEDIS-
play.
sh
” appears if the selected Memory channel is a
blank channel.
e Enter the frequency, operating mode, and other
data into the Memory channel.
r Hold down [MW] for 1 second to program the con-
tents into the Memory channel.
s4HREEBEEPSSOUNDWHENTHEMEMORYPROGRAMMINGIS
complete.
./4% If you perform the above operations in a pre-
programmed channel, the previous channel data will
be overwritten.
N-EMORYCHANNELPROGRAMMING
;%8!-0,%=
Programming 7.088 MHz/LSB into the Mem-
ory channel 12 while in the VFO mode.
;%8!-0,%=
Programming 21.280 MHz/USB into Memory
channel 18 while in the Memory mode.
[VFO/MEMO] [MW]
[] []