8-14
BASIC MANUAL
8
SET MODE
Connectors
»
SET > Connectors
Speaker MIC AF Output (Default: ON)
microphone is connected.
•
device.
•
Output device.
SP Jack Function (Default: Speaker)
Selects the audio output from the [EXT-SP] jack.
• Speaker: The audio is output from only the Left
speaker.
• Phone: The audio is output from only the Left
headphone.
•
and Left channels through the
Phones Level (Default: 0)
Sets the audio output level ratio of the headphone and
»
SET > Connectors > USB/AV-OUT AF/IF Output
L The signal is output from the [AV-OUT] jack only
when in the ATV mode.
Output Select
Selects the signal output from the [USB] port and the
[AV-OUT] jack.
•
•
AF Output Level (Default: 50%)
AF SQL
Selects whether or not to output the audio from the [USB]
port and the [AV-OUT] jack, depending on the squelch
•
regardless of the transceiver’s
squelch level.
• ON: The squelch opens and closes,
according to the transceiver’s squelch
level.
AF Beep/Speech... Output
Sets the Beep and Speech audio output setting of
the [USB] port and the [AV-OUT] jack, when “Output
•
• ON: The beep and speech audio are output.
IF Output Level (Default: 50%)
»
SET > Connectors > LAN AF/IF Output
Output Select
Selects the signal output from the [LAN] connector.
•
•
AF SQL (Default: ON)
Selects whether or not to output the audio from the
[LAN] connector, depending on the squelch state,
•
regardless of the transceiver’s
squelch level.
• ON: The squelch opens and closes,
depending on the transceiver’s
squelch level.
»
SET > Connectors > MOD Input
USB MOD Level (Default: 50%)
LAN MOD Level (Default: 50%)
Sets the modulation input level of each interface.
DATA OFF MOD (Default: MIC,USB)
DATA MOD (Default: USB)
to input the modulation signal when the Data mode is
AV-IN MOD Level (Default: 50%)
Sets the modulation input level of the Audio terminal
on the [AV-IN] jack.
ATV MOD (Default: MIC, AV-IN)
Selects the connector(s) to input the modulation signal
when in the ATV mode.
To Next Page
Loading...
