8-17
BASIC MANUAL
SET MODE
8
8
Control Port (UDP) (Valid after Restart)
(Default: 50001)
Sets a port number for the control signal transfers
between the IC-905 and the remote station, when you
remotely control the IC-905.
Serial Port (UDP) (Valid after Restart)
(Default: 50002)
Sets a port number for the serial data transfers
between the IC-905 and the remote station, when you
remotely control the IC-905.
Audio Port (UDP) (Valid after Restart)
(Default: 50003)
Sets a port number for the audio signal transfers
between the IC-905 and the remote station, when you
remotely control the IC-905.
Internet Access Line (Valid after Restart)
Selects the Internet access line setting for the IP
remote control.
»
SET > Network > Remote Settings >
Network User1
»
SET > Network > Remote Settings >
Network User2
Network User1 ID
Network User2 ID
Sets a user name of up to 16 characters to use when
you remotely control the IC-905.
Network User1 Password
Network User2 Password
Sets a user password.
L The password must include a minimum of 8 characters
and a maximum of 16 characters.
L You cannot use a password that consists of only the
same characters.
Network User1 Administrator (Default: NO)
Network User2 Administrator (Default: NO)
Selects whether or not to set the user as an
administrator.
communication between the IC-905 and the remote
station.
»
SET > Network > Remote Settings
Network Radio Name (Default: IC-905)
Sets the IC-905’s name of up to 16 characters that is
displayed in the remote control software, when you
remotely control the IC-905.
To Next Page
Loading...
