What to do if my Icom IC-A24 has no sound from the speaker?
If you're not getting any sound from the speaker of your Icom Transceiver, it could be due to a couple of reasons. The squelch level might be set too high, blocking out the sound. Try setting the squelch to the threshold point. Another possibility is that the volume level is set too low. Adjust the [VOL] to a suitable level.
What to do if the display channel cannot be selected on my Icom IC-A24 Transceiver?
If you're unable to select the display channel on your Icom Transceiver, the lock function may be activated. To deactivate it, push, then push [7• ].
How to enable beep sounds on Icom Transceiver?
If you are not hearing any beep sounds on your Icom Transceiver, it is possible that the beep tones are turned OFF. To turn them back on, push, then push [8•BEEP] to adjust the beep tone level.
General| Channel Spacing | 25 kHz |
|---|---|
| Operating Voltage | 7.2 V DC |
| Mode | AM |
| Voltage | 7.2 V DC |
| Frequency Range | 118.000-136.975 MHz |
| Output Power | 5.0 W (PEP), 1.5 W (carrier) |
| Battery Life | 8 hours (with BP-210N) |
| Number of Memory Channels | 200 channels |
| Current Drain (Transmit) | 1.5 A |
| Modulation | AM |
| Number of Channels | 200 channels |
| Current Drain (Receive) | 300 mA (internal SP), 500 mA (external SP) |
Covers critical safety instructions regarding battery, operation, environment, and FCC rules.
Describes the functions of the numeric and special digit keys.
Explains the primary functions of basic controls like LIGHT, PTT, VOL, DIAL, and ANT.
Step-by-step guide to setting frequencies using the keypad.
Instructions for setting frequencies using the tuning dial.
Guidelines for transmitting, including antenna use and microphone technique.
How to select memory channels using the tuning dial or keypad.
Step-by-step guide to storing frequencies into memory channels.
Details on how to program and display 6-character memory names.
Illustrates programming a frequency and name into memory channels.
How to assign custom 6-character names to memory channels.
Diagrams and explanations of VOR indicators in DVOR and CDI modes.
How to select and use CDI and DVOR modes for navigation.
How the IC-A24 displays deviation and guides flight to a VOR station.
Visual example of the aircraft being on course with VOR display.
How to set and follow a desired course using VOR navigation.
Step-by-step illustration of entering a desired course bearing.
How duplex function allows calling flight service while receiving VOR.
Visual example of the aircraft being off course with VOR display.
Method to determine location by cross-referencing two VOR stations.
Visual guide to crosschecking position using VOR stations.
Important safety warnings for handling and using battery packs.
Crucial safety information on RF exposure, duty cycle, and antenna placement.
Solutions for problems like no power or no sound from the speaker.
Troubleshooting for transmission failures and inability to change channels.
To Next Page
