Icom IC-M25

16
DUALWATCH AND TRI-WATCH
6
Description
Dualwatch and Tri-watch are convenient to monitor Channel
16 while you are operating on another channel.
Operation
SelectDualwatchorTri-watchintheSetmode.(Page19) q
Select the desired channel. w
e
Hold down [DUAL] (SCAN) for 1 second to start
Dualwatch
or Tri-watch.
 •
“DUAL” blinks during Dualwatch. “TRI” blinks during Tri-watch.
 • A beep tone sounds when a signal is received on Channel 16.
r To cancel Dualwatch or Tri-watch, push [DUAL] (SCAN)
again.
When a signal is received:
• On Channel 16
Dualwatch/Tri-watch pauses on Channel 16 until the
signal disappears.
• On the Call channel
Tri-watch switches to Dualwatch until the signal on the
Call channel disappears.
Dualwatch
Tri-watch
Ch 88
Ch 16
Ch 88
Ch 16
Ch 9
Monitors Channel 16
while receiving on
another channel.
Monitors Channel 16 and
the Call channel while
receiving on another channel.
Normal
channel
Normal
channel
Call
channel
[Example]: Operating Tri-watch on INT channel 07.
Tr i-watch starts.
A signal is received on the
Call channel.
The signal received on
Channel 16 takes priority.
Tr i-watch resumes after
the signal disappears.