Icom IC-M330

14
4
BASIC OPERATION
New2001
■ Editing a channel name
You can edit the name of each operating channel and weather
channel, using numbers, uppercase letters, symbols, and
a space. This enables easy recognition of the channels or
stations. All VHF marine channels are set with default names.
1. Push [▲] or [▼] to select the channel to edit.
2. Push [◄] or [►] to display
NAME
.
L You cannot edit a channel name during Dualwatch, Tri-watch,
or a scan.
3. Push
NAME
.
• The “CHANNEL NAME” screen is displayed.
4. Edit the channel name.
TIP:
• Select
!$?
to enter symbols, and select
123
to enter
numbers and letters.
• Select characters or a space using [▲]/[▼]/[◄]/[►].
• Select “◄” or “►” to scroll.
• Push [ENT] to enter the selected character.
• Select “←” or “→,” or rotate [DIAL] to move the cursor.
• Push
EXIT
to cancel editing.
5. Push
FIN
to save the edited name and return to the
operating screen.
■ AquaQuake Water Draining
function
Water in the speaker grill may mufe the sound coming
from the speaker. The AquaQuake Water Draining function
removes water from the speaker grill by vibrating the speaker
cone.
1. Push [◄] or [►] to display
AQUA
.
2. Hold down
AQUA
to turn ON the function.
• A low frequency vibration beep sounds to drain the water,
regardless of the volume level setting.
L This function is activated for a maximum of 10 seconds,
even if you continue to hold down
AQUA
.
3. Release the key to turn OFF the function.
CAUTION: DO NOT use the AquaQuake Water Draining
function when an external speaker is connected.