Icom IC-M330 - Multiple-Task Mode

40
7
DSC OPERATION
New2001
■ Multiple-task mode
(ForonlytheUSAversion,dependingonthepresetting.)
IftheMultiple-taskfunctionisenabled,thetransceivercan
hold up to 7 tasks. Therefore, you can handle more than 2
DSCtaskssimultaneouslybyswitchingbetweentheDSC
tasks.
TousetheMultiple-taskmode,select“Multiple”inthe
“Procedure” on the Menu screen. (p.44)
Menu > DSC Settings > Procedure
WhentheMultiple-taskmodeisactivated,
TASK
is displayed
on the operating screen.
NOTE: TheTaskmodehasaTime-outTimer(TOT)
function.Afteracertainperiodoftimehaspassedwithout
anyoperationonatask,thetransceiverautomaticallyexits
the Task mode and returns to the operating screen.
WhenaTime-outTimeractivates,analarmsoundsanda
countdownmessageisdisplayedfor10seconds.
D Holding a DSC task
IntheMultiple-taskmode,youcanholdoractivatetheDSC
taskasfollows.
Example: When a Group call is received:
1. Push
ALARM OFF
to turn OFF the alarm.
• Thereceivedcall’sinformationisdisplayed.
2. Push
HOLD
.
• ThereceivedGroupcalltaskisheldintothetasklistand
returns to the operating screen.