Icom IC-M330 - Sending a Group Call

28
7
DSC OPERATION
New2001
D Sending a Group call
AGroupcallenablesyoutosendaDSCcalltoonlya
specicgroup.
L YoucansendaGroupcalltoapre-enteredgroupaddress,or
manually enter the address before sending.(p.18)
1. Push
OTHER DSC
.
• The “OTHER DSC” screen is displayed.
L You can also display the “OTHER DSC” screen by selecting
the “Other DSC” item on the Menu screen.
2. Select “Type,” and then push [ENT].
• The
“MESSAGETYPE”screenisdisplayed.
3. Select“Group,”andthenpush
[ENT].
• TheGroupcallisselected,andreturns
to the “OTHER DSC” screen.
4. Select “Address,” and then push
[ENT].
• The “ADDRESS” screen is displayed.
5. SelectthegrouptosendaGroup
call to, and the push [ENT].
L You can also select “Manual Input” to
manually enter the target group.
6. Select “Channel,” and then push
[ENT].
7. Select the channel to assign, and
then push [ENT].
L The assigned channels are preset by
default.
8. Push
CALL
tosendtheGroupcall.
• “TransmittingGroupCall”isdisplayed,andthentheassigned
channel is automatically selected.
L If Channel 70 is busy, the transceiver stands by until the
channel becomes clear.
9. Holddown[PTT]tocommunicate.