Icom IC-M330 - Sending Other DSC Calls

24
7
DSC OPERATION
New2001
■ Sending DSC calls (other)
NOTE: To ensure proper DSC operation, be sure to
correctly adjust the “CH 70 SQL Level” item on the Menu
screen. (p.43)
D Sending an Individual call
An Individual call enables you to send a DSC signal to only
aspecicstation.Youcancommunicateafterreceivingthe
Acknowledgement“Abletocomply.”
1. Push
OTHER DSC
.
• The “OTHER DSC” screen is displayed.
L You can also display the “OTHER DSC” screen by selecting
the “Other DSC” item on the Menu screen.
7. Select a channel to assign, and
then push [ENT].
L The assigned channels are preset by
default.
8. Push
CALL
to send the Individual
call.
• “Transmitting Individual Call” is
displayed, and then “Waiting for ACK”
is displayed.
L If Channel 70 is busy, the transceiver
stands by until the channel becomes
clear.
9. When you receive an
Acknowledgement“Abletocomply”:
• An alarm sounds.
• The screen to the right is displayed.
10. Push
ALARM OFF
to turn OFF the
alarm.
• The channel assigned in step 7 is
automatically selected.
L If the called station cannot use the
channel that you assigned, a different
channel is selected by the station.
11. Holddown[PTT]tocommunicate.
2. Select “Type,” and then push [ENT].
3. Select “Individual Call,” and then
push [ENT].
• Returns to the “OTHER DSC” screen.
4. Select “Address,” and then push
[ENT].
5. Select the station to send an
Individual call to, and the push
[ENT].
• Returns to the “OTHER DSC” screen.
L You can also select “Manual Input” to
manually enter the target station.
6. Select “Channel,” and then push
[ENT].