Icom IC-M330 - D Receiving a Position Request Call

36
7
DSC OPERATION
New2001
D Receiving a Position Request call
 (ForonlytheUSAversion,dependingonthepresetting)
When a Position Request call is received:
• The alarm sounds for 2 minutes.
• “RCVD POS Request” is displayed.
1. Push
ALARM OFF
to turn OFF the alarm.
2. Pushthesoftwarekeybelowtheintendedoperation.
IGN
(Ignore)
• Ignores the call and returns to the operating screen.
• The call is saved in the DSC Log.
• “
” blinks continuously until you display the call
message.
ABLE
(Able to Comply)
• SendstheAcknowledgement“AbletoComply.”
• The call is saved in the DSC Log.
UNABLE
(Unable to Comply)
• SendstheAcknowledgement“UnabletoComply.”
• DisplaystheAcknowledgementinformation,andthen
returns to the operating screen by pushing
EXIT
.
• The call is saved in the DSC Log.
ACPT
(Accept)
• Accepts the call.
• Displaysthereceivedcall’sinformation.
• The call is saved in the DSC Log.
• Push
ABLE
or
UNABLE
, then push
CALL
to send the
Position Reply call. (p.31)
NOTE:
• If the Auto ACK function is set to “Auto,” the Position
Reply is automatically sent to the calling station. (p.42)
• However,eveniftheAutoACKfunctionissetto
“Manual,”afterreceivingaDistressAcknowledgement,or
whileintheDistressCancelcallprocedure,thePosition
Reply is automatically sent to the calling station.