Icom IC-M330

31
DSC OPERATION
7
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
D Sending a Position Reply call
SendaPositionReplycallwhenaPositionRequestcall
is received. If the Auto ACK function is set to “Auto,” the
Acknowledgementisautomaticallysenttothecalling
station. (p.42)
1. While a Position Request call is
being received, push
ALARM OFF
to
turn OFF the alarm.
2. Push
ACPT
.
• Thereceivedcall’sinformationis
displayed.
3. Push
ABLE
to send an “Able to
Comply”Acknowledgement,orpush
UNABLE
to send an “Unable to Comply”
Acknowledgement.
L IfnovalidGPSpositionisreceived,
you can manually enter the position
and time in “Position” item on this
screen. See “Entering the position and
time” on page 20 for details.
4. Push
CALL
to send the Position Reply
call
.
6. Push
CALL
to send the Position Request call.
• “Transmitting Position Request” is displayed, and then the
assigned channel is automatically selected.
L If Channel 70 is busy, the transceiver stands by until the
channel becomes clear.
7. WhenyoureceiveaPositionReply:
• An alarm sounds.
• The screen to the right is displayed.
8. Push
ALARM OFF
to turn OFF the
alarm.
9. Push
CLOSE
.
• The received information is displayed.
10. Push[▲]or[▼]toscrollthescreen
thencheckthetargetʼsposition.
11. Push
STBY
, and then
OK
to return
to the operating screen.
5. Push
STBY
, and then
OK
to return to the operating
screen.