Icom IC-M505

9
3
BASIC OPERATION
3
■ Call channel programming
You can program the call channel with your most often-used
channels in each channel group for quick recall.
q While pushing and holding
[H/L], push [DIAL•DUAL•
GRP] one or more times to
select the desired channel
group (INT, USA, ATIS or
DSC) to be programmed.
w Push [16•C] for 1 sec. to
select the call channel of
the selected channel group.
 •“CALL” and call channel
number appear.
e Push [16•C] again for 3
se c . ( unti l a lon g b eep
changes to 2 short beeps)
to enter call channel pro-
gramming.
 •Channelnumberstartsblink-
ing.
r Rotate [CHANNEL] to se-
lect the desired channel.
t Push [16•C] to program the
displayed channel as the
call channel.
 •Push[CLR] to cancel.
 •Thechannel numberstops
blinking.
25W INT
DUP
TAG
34°34.506N
123°23.236W
UTC 12:00 INTL
25W INT CALL
TAG
34°34.506N
123°23.236W
UTC 12:00 CALLING
25W INT CALL
TAG
34°34.506N
123°23.236W
UTC 12:00 CALLING
25W INT CALL
DUP
TAG
34°34.506N
123°23.236W
UTC 12:00 INTL
25W INT CALL
DUP
TAG
34°34.506N
123°23.236W
UTC 12:00 INTL