Icom IC-M505 - Page 33

27
6
DSC OPERATION
6
e Rotate [CHANNEL] to select the desired pre-pro-
grammed individual address or “Manual Input,” push
[CHANNEL•ENTER].
 • The ID code for the individual call can be set in advance. (p. 17)
 • When “Manual Input” is selected, set the 9-digit MMSI
number for the individual you wish to call by rotating [CHANNEL].
1st digit must not be ‘0’.
--DSC Menu--
Select Address
Manual Input
John
˘Paul
George
Michael
<CLR˘Exit / ENT˘OK>
NOTE: When a base station is selected in step e, the voice
channel is automatically specified by the base station, then
“Individual Call Ready” will appear. Therefore,
skip step r and go directly to step t.
r Rotate [CHANNEL] to select a desired intership
channel, push [CHANNEL•ENTER].
 •Intershipchannelsarealreadypresetintothetransceiverin
recommended order.
--DSC Menu--
Select Intership CH
˘08
69
77
06
<CLR˘Exit / ENT˘OK>
--DSC Menu--
Individual Call Ready
<CLR˘Exit / ENT˘OK>
t Push [CHANNEL•ENTER] to transmit the individual call.
 •IfChannel70isbusy,thetransceiverstandsbyuntilthechan-
nel becomes clear.
--DSC Menu--
Individual Call
Transmitting