Icom rs-ba1 - Setting Your Pcs Environment

2
WHEN CONNECTING TO THE NETWORK THROUGH A PC
23
Congure your PC’s environment in the Base station’s Remote Utility.
The settings will take effect after rebooting the Remote Utility.
When you rst open the Remote Utility, the Settings screen appears.
After conguring the settings, you can display other setting screens.
■ Setting your PC’s environment
1. Click “Options.”
2. Click “Settings.”
• The “Settings” screen is displayed.
3. Congure the settings.
4. Click <OK> to save the settings.
• The “Take effect after restarting the application”
screen is displayed.
5. Click <OK>.
The settings will take effect after rebooting the
Remote Utility.
1Click
2Click
3Set
4Click
5Click
1
2
3
4
1PC Name
Enter a name for your PC of up to 16 characters.
DO NOT use the same name for more than one PC on your network.
2Port numbers
Enter the port numbers of the Control, Serial, and Audio port.
You should use the default port numbers for these ports.
3Internet Access Line
Select your internet access line type.
4Language
Select the software display language.
The selected language will be used as the Help le language.
NOTE:
If you congure the remote control system through the Internet, and change the port number of the Control,
Serial or Audio port, you should congure the port forwarding settings and the IP lter settings on your router
once again. (p. 12)