Icom rs-ba1 - D When Configuring the Remote Control System through the Internet; Dwhen Configuring the Remote Control System through the Internet

3
WHEN CONNECTING TO THE NETWORK DIRECTLY
56
D When conguring the remote control system through the Internet
If you congure the remote control system through the Internet, Remote stations can access the Server using its
public IP address. If you utilize a Dynamic DNS service, Remote stations can access the Server by not only its
public IP address, but also by its domain name.
To let Remote stations access the Server using its public IP address
A public IP address is an address that is accessible over the global Internet. If you use a dynamic public IP
address, it is chosen from a pool of available addresses and changes each time you connect to the Internet.
Because of this, Remote stations will have to match the IP address each time to access the Server.
If you use a dynamic public IP address, we recommend that you utilize the Dynamic DNS service to allow the
Remote stations to access the Server using its domain name, or use a static public IP address.
Ask the router’s manufacturer about how to congure your router to set the public IP address.
IP address: 192.168.0.10
IP address
WAN:
✽✽✽.✽✽✽.✽✽✽.✽✽✽
LAN: 192.168.0.1
PC
Router
Router
Request “✽✽✽.✽✽✽.✽✽✽.✽✽✽
”
(Public IP address)
(Radio/Server)
InternetInternet
Base station
Remote station
IC-7851
IC-7850
IC-7800 (firmware version 3.00 or later)
IC-7700 (firmware version 2.00 or later)
IC-7610
■ Confirming Server Address or Network Name (Continued)