Icom rs-ba1 - Remote Controllers Basic Operation; Connecting to a Radio with the Remote Controller

71
REMOTE CONTROLLER’S BASIC OPERATION
5
This section describes how to connect to a radio and remotely control it using the Remote Controller.
There are two ways to connect to the radio with the Remote Controller:
1. Connecting to the radio through a network using the Remote Utility (p. 72)
2. Directly connecting to the radio that is physically connected to your PC, instead of using the Remote Utility (p. 73)
L When using the Network function of the radio (IC-7610, IC-7700 with rmware version 2.00 or later, IC-7800
with rmware version 3.00 or later, IC-7850, or IC-7851), connect to the radio through the network.
■ Connecting to a radio with the Remote Controller
Connects to the radio (pp. 72, 73)
About the Remote mode (p. 74)
Displays the Connect Setting screen (pp. 72, 73)
To use transmit audio input from the PC (p. 74)
NOTE:
See the RS-BA1 Remote Controller’s help le for remote operation details, such as how to change the
frequency, or turn ON each function.
To display the help le, click “Contents” in the Help menu on the Remote Controller, or push the [F1] key on your
PC’s keyboard.