Icom rs-ba1 - Page 76

3
WHEN CONNECTING TO THE NETWORK DIRECTLY
48
■ Network setting (Continued)
• For the IC-7610
1. “Network Control” setting
1. Push [MENU] to display the MENU screen.
2. Touch [SET] to enter the Set mode.
3. Touch [Network].
4. Touch “Network Control.”
5. Touch “ON.”
NOTE:
If you select “OFF,” the Remote station cannot
access the radio.
2. “Default Gateway” setting
NOTE:
This setting is necessary when the remote control
system is congured through the Internet.
6. Touch “Default Gateway.”
7. Enter the IP address of the LAN side on the
router.
(Example: 192.168.0.1)
Enter
3. “Control Port (UDP)”
“Serial Port (UDP)”
“Audio Port (UDP)” conrmation
8. Touch [▲] or [▼] to display “Control Port (UDP),”
“Serial Port (UDP)” or “Audio Port (UDP).”
9. Conrm the port numbers of the Control, Serial
and Audio ports.
You should use the default port numbers for
these ports.
e Confirm
NOTE:
If you congure the remote control system through
the Internet, and change the port number of the
Control, Serial or Audio port, you should congure
the port forwarding settings and the IP lter settings
on your router once again. (p. 12)
If you change the port number, push [QUICK] and
touch “Default” to return them to their defaults.
4. “Internet Access Line” setting
10. Touch “Internet Access Line.”
11. Touch your internet access line type.
• FTTH: Fiber To The Home
• ADSL/CATV: ADSL or Cable television
r Select
5. Saving the settings
12. Reboot the radio.
The settings will take effect after rebooting.