iDiPOS TP-80 - ESC!n; Select print mode(s)

4
performs the same operation specified by this command. The user must
consider above condition.

This command should not be used within the data sequence of another
command that consists of 2 or more bytes.

This command is effective even when the printer is disabled with ESC = (Select
peripheral device).
[Reference] ESC p
8. ESC FF (*)
[Name] Print data in page mode
[Format] ASCII ESC FF
Hex 1B 0C
Decimal 27 12
[Description] In page mode, prints all buffered data in the printing area collectively.
[Details]

This command is enabled only in page mode.

After printing, the printer does not clear the buffered data, setting values for
ESC T and ESC W, and the position for buffering character data.
[Reference] FF, ESC L, ESC S
9. ESC SP n
[Name] Set right-side character spacing
[Format] ASCII ESC SP n
Hex 1B 20 n
Decimal 27 32 n
[Range] 0 ≤ n ≤ 255
[Description] Sets the character spacing for the right side of the character to [ n  horizontal or
vertical motion units].
[Details] • When characters are enlarged n times, the right-side character spacing is n
times normal value.
• This command sets values independently in each mode (standard and page
modes).
• The horizontal and vertical motion unit are specified by GS P. Changing the
horizontal or vertical motion unit does not affect the current right-side spacing.
• The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs in page mode,
depending on starting position of the printable area as follows:
1 When the starting position is set to the upper left or lower right of the
printable area using ESC T, the horizontal motion unit ( x) is used.
2 When the starting position is set to the upper right or lower left of the
printable area using ESC T, the vertical motion unit ( y) is used.
• The maximum right-side spacing is 31.91mm (255/203) inches. Any setting
exceeding the maximum is converted to the maximum automatically.
[Default] n = 0
[Reference] GS P
10. ESC ! n