iDirect Satellite Router Installation and Commissioning Guide 53
iDX Release 3.3
10 Loading Options Files
with Web iSite
This chapter describes how to load the options file on the X1, X7, and e150 Satellite Routers
using the Web iSite application.
This chapter includes the following sections:
• “Options File” on page 53
• “Downstream Template” on page 56
10.1 Options File
Note: If using a Downstream Template instead of individual options files, skip to
“Downstream Template” on page
56.
The remote options file contains network a
nd site-specific information such as operating
frequencies, geographic location, and other network parameters. Options files are generated
in iBuilder, and provided to the installer by the Network Operator.
An options file must be loaded on the Satellite
Router in order to acquire into the network.
After loading the remote package file, the op
tions file may be loaded. Loading an options file
is similar to loading a remote software package.
To Load the Options File:
1. In the Load Option
s File section of the File Management page, click Browse.
2. Navigate to the folder on the local PC that contains
the applicable site-specific options
file.
3. Double-click the options fil
e or click Open.
4. Verify that the correct filename is displayed in the Load P
ackage window (Figure 33).
To Next Page
Loading...
