56
6.3. V-Cut Tool
Picture 19 Picture 20
First make sure blade fitting ramps of the V-cut holder, then put the kidney-shaped slot into the round positioning
pins.(picture 19)
V-cut tableting squeeze blade, screw two M4*8 bolt(picture 20),blade installation is complete.(note: If the cylindrical
pin don’t get stuck blade, it will lead to blade breakage and scarp)
Picture 21 Picture 22
Put the V-CUT into the cutting holder (picture 21&22).(note: the v-cut red point corresponds to the cutting holder’s red
dot, otherwise it will cause installation error.
To Next Page
Loading...
