57
Picture 23 Picture 24
Put the finished oblique turret on the bottom of oblique knife mount, make them fit(picture 23).
There are two different cylindrical pin on the oblique knife mounts, with corresponding cylindrical pin hole, insert
easily, otherwise it will cause no installed or damage parts and other issue. Oblique knife mount and oblique turret
should completely butt(picture 24）.
Picture 25 Picture 26
Use inner hexagon 4
th
wrench tighten oblique knife mount hex bolts (picture 25), oblique knife mount and oblique
turret will gradually fit securely.
Tool installation is complete(picture26). Shake oblique turret by hands to make sure there is no gap and shake
phenomenon, the installation is correct. Special attention to the blade to prevent the blade cut hands at any time.
To Next Page
Loading...
