IGS Diamond Progressive - Page 18

16 4. DIP Switch Settings
DIP SW 2 1 2 3 4 5 6 7 8
OFF OFF
TOUCH
ON ON
9 OFF
LINER
25 ON
Notes:
 To use linking mode,

On each of the PC board, set No.8 of DIP SW1 to use
Link Mode
.

On each of the PC board, set No.1~ 5 of DIP SW1 to use
different slave ID
. Note that
ID #1 must be set first
.

After the setting, use the reset toggle to use Link Mode.
 Please reset after adjusting SLAVE ID, LINK MODE and LINER.
 Please use the Connection Diagram that corresponds to the button panel.