7. Settings under Linking Mode 35
(b) Its previous web-activated keyout process (if any) has been finished.
(c) The machine is not in any error status.
The key out steps:
1. Just click the
Keyout
button in the row of the slave machine you want to key out credits.
Note that you cannot key out credits smaller than the Key Out Rate (set in System Adjust
page).
2. Wait until the message indicating that keyout is OK appears.
Possible messages you will receive include (e.g, key out credits on the machine with Slave
ID 1):
“Slave 1 Keyout PROCESSING…”
“Slave 1 Keyout OK”
“Slave 1 Keyout FAIL”
If you get this message, check that:
(a) The slave machine is properly linked and in online status
(b) Its previous web-activated keyout process (if any) has been finished.
(c) The machine is not during play or in any error status. The machine is not during pl
3. After the OK message appears, wait a moment for the keyout process to complete. When
keyout is done, the keyout credits will accumulate to
Total Key Out
.
To Next Page
Loading...
