Ikegami HTM-1517R - Description of MENU 3 Functions

36
⑤Setting the operation mode at aspect change
 Associate the change of aspect settings with the
switching of inputs.
AUTO: Display with the aspect ratio preset for
each channel.
MANUAL: Fixed aspect ratio without automatic
change along with channel switching.
Apply this setting if 4:3/16:9 switching
is done using parallel remote connec-
tion.
⑥ Setting the wireless remote controller
 Set the remote controller in use.
RCT-20: Setting for RCT-20A/30A
RCT-17: Setting for RCT-17/27
⑦ Setting the remote controller ID number
 Set the monitor ID numbers ( 01 ~ 99 ).
 When performing remote control operations using
wireless remote controller (RCT-30A) or serial re-
mote controller (SRC-301Z), the monitors can be
remote controlled individually with the ID num-
bers ( 01 ~ 99 ) assigned to the monitors.
⑧ Setting the degauss ON timer
 Set the operation start time of the degauss (de-
magnetization) function, which operates automati-
cally when the power is turned on, using 0 ~ 9
groups.
 By setting in groups 0 to 9 , the overall rush
current which flows when the power of all devices
of the system are turned On can be minimized.
 Timer operation
When set to 0, the degauss function will automati-
cally start about 4 seconds after the power is turned
on. The time delays with an increment of 0.5 sec-
onds each time the setting is increased by 1.
The table below shows the approximate time until
the degauss function starts after the power is
turned on.
Setting Operation Start Time Setting Operation Start Time
0 4.0 seconds 5 6.5 seconds
1 4.5 seconds 6 7.0 seconds
2 5.0 seconds 7 7.5 seconds
3 5.5 seconds 8 8.0 seconds
4 6.0 seconds 9 8.5 seconds
(5)Description of MENU 3 Functions
①SelectingFILE
②Selectingthedestinationfile
③Settingthefilechange
④Settingtorestoredefault
MENU3<CHANGEDATA>
1.SELECTFILE FILE1
2.STOREFILE FILE3
3.CHANGEFILE MANUAL
4.LOADFACTORY ALL


NEXT→(MENU)
SELECT→(ENT)EXIT→(ESC)
① Selecting FILE
 Select any of REFERENCE, FILE 1, FILE 2 and
FILE 3.
 The four files store the following 9 types of data.
HUE, CONTRAST, R.BACKGROUND, CHROMA,
G.GAIN G.BACKGROUND, BRIGHTNESS, B.GAIN
B.BACKGROUND
 The operation is the same as the FILE switch in
the drawer panel.
② Selecting the destination file
 The data (9 types) in the file selected in ① are all
transferred (overwritten) to the file selected here.
 When ALL is selected, the data in the file selected
is transferred to all files (REF, FILE 1~3).
③ Setting the file change
 Set AUTO or MANUAL for switching the FILE set-
tings.
AUTO: FILE setting for each channel is
changed automatically along with
channel switching.
MANUAL: FILE setting is fixed.
④ Setting to restore default
 Perform this setting to restore the default settings.
ALL: Factory settings are restored for all PRE-
SET data, all MENUs and switches.
PRESET: Factory settings are restored for all
PRESET data.
MENU&SW: Factory settings are restored for all
MENUs and switches.
FILEselectedin①


…
Transfer9typesofdata

FILEselectedin②