IMO iDrive - Chapter 1 Safety Precautions; Operation Precautions; Before Power up

Chapter 1 Safety Precautions
1-1
Chapter 1 Safety Precautions
1.1 Operation Precautions
1.1.1 Before Power Up
Caution
The line voltage applied must comply with the inverter’s specified input voltage.
Danger
Make sure the main circuit connections are correct. L1(L), L2, and L3(N) are power-input
terminals and must not be confused with T1, T2 and T3. Otherwise, the inverter might be
damaged.
Caution
 To avoid the front cover from disengaging, do not pull the cover when carrying the inverter for
which the heat sink should be held. Avoid dropping the inverter as damage could occur.
 To avoid fire, do not install the inverter on a flammable surface. Always install on metal
surface if possible.
 If several inverters are placed in the same control panel, add extra heat dissipators to keep the
temperature below 50
o
C to avoid overheating or fire.
 When removing or installing the remote keypad, turn the power off first, and operate the
keypad following the instruction diagrams to avoid error or no display caused by poor
contact.
Warning
When connected as detailed in this manual, this product complies with IEC 61800-3, with
built-in filter for Unrestricted Distribution and when using an external filter for Restricted
Distribution. Conformance. It should be tested before use in some environments.