1.2.1 Inventory Mode
If you want to keep the barcodes in the buffer of BCST-20 for multiple
uploading, you can choose inventory mode. In inventory mode,
BCST-20 will count the number of the barcodes automatically, and
control the time, position etc. for uploading. Also, you can clear the
barcodes in the buffer after uploading. Following is the setup method:
1. Read ‘Enter Inventory Mode’ barcode to enter into the inventory
mode
2. If you want to recover to normal mode, read the ‘Enter Normal
Mode’ barcode
3. Read the ‘Clear the barcodes in the buffer’ barcode to clear the
barcodes (only suitable for inventory mode)
4. Read ‘Data Uploading’ barcode to upload the barcodes in the
buffer (only suitable for inventory mode)
5. Read ‘Upload Counting’ barcode to count the number of the
barcodes (only suitable for inventory mode)
Note: Inventory function can be used under any scan mode
mentioned in 1.5.
Enter Inventory Mode
Enter Normal Mode
Clear the barcodes in the buffer
Data Uploading
Upload Counting
16
To Next Page
Loading...
