Inateck BCST-20 - 3.8 Code 128

39
3.8 Code 128
Decide whether or not to enable Code 128. The BCST-20 Scanner
defaults enable Code 128.
Note: Read the "Disable Code 128" barcode will make the scanner
not able to read the Code 128 barcode. Thus, if the scanner cannot
read the Code 128 barcode, please try to read "Enable Code 128" to
reset.
For Example: Disable Code 128
1. Read the "Enter Setup" barcode;
2. Read the "Disable Code 128" barcode;
3. Read the "Exit with Save" barcode.
Enter Setup
Exit with Save
Exit without Save
Disable Code 128
(*) Enable Code 128