25
1.8 Digit capacity Setting
For example, the interception of barcodes in a fixed length.
1. Scan the “Enter Setup” barcode.
2. Scan the “fixed digit capacity” barcode.
3. Scan the “zero fill” barcode. (Note: This step is needed only when
you want to add zeros in front of the original barcodes.)
4. Scan the numeric barcode in Appendix I. (Reading 1 then 5, means
15 digits.)
5. Scan the "Exit with Save" barcode.
P.S. To restore the original barcodes, scan “Enter Setup”- “fixed digit
capacity” - "Exit with Save" .
Enter Setup
Exit with Save
Exit without Save
Fixed digit capacity
Zero fill
To Next Page
Loading...
