4 The PROFview XL Application Software User Manual PROFview XL
4 The PROFview XL Application Software
4.1 System requirements
To ensure the correct installation of the PBT application software, your PC or notebook should meet the fol-
lowing minimum requirements and possess one of the operating systems listed below:
Hardware:
Processor: Intel Pentium III, AMD Athlon or higher
min. 128 MB main memory
Graphics card with 16-bit color depth (24-bit recommended)
Resolution: 1,024x768 pixels or higher
CD/DVD ROM drive
free USB port
Supported operating systems:
Microsoft® Windows® 98 Gold and Second Edition (SE)
Microsoft® Windows® Millennium (ME)
Microsoft® Windows® 2000
Microsoft® Windows® XP
Microsoft® Windows® VISTA (32 Bit-Version)
Note:
Microsoft® Windows® NT 4.0 and Windows® 95 are not supported.
4.2 Installing the software
The PC software is supplied on CD. The installation program will set up the PBT application software on your
system and will install the USB driver required for your device. To this end, perform the following steps:
1. Insert the CD into the appropriate drive of your PC. Thereafter, a selection menu window is automatically
opened.
6
2. From here you can select the PC software in the desired language for installation.
3. Follow the instructions of the setup program.
4. After the setup, your PC must be restarted.
Note:
To install the USB driver, you must possess administrator rights.
6 If the selection menu window does not open automatically, launch it via "START" → "Run..." → "{drive letter of your CD ROM
drive}:\PBT-v170.exe" → "OK" or start the setup program directly from "{drive letter of your CD ROM drive}:\fscommand\SoProfi-
busTesterE.msi"
12 PROFview XL
To Next Page
Loading...