IDS440 Users Manual version 4.2
60
IDS440 Specifications
Display 1 inch x 6-digit numeric, 6 LED status indicators.
Keyboard Sealed keyboard with tactile feel.
I/O Ports Load Cell Interface Port.
Serial port 1 - RS232 or Cur. Loop.
Serial port 2 - RS232 or RS485.
9 TTL outputs.
8 TTL inputs.
Display Graduations 120,000 graduations (industrial)
10,000 hb44.
Display Increments 1, x2, x5, x10, x20, x50, x100.
Decimal Point 0 to 4 decimal places.
Internal Graduations 1,024,000.
Conversion Rate 60/sec @60hz line frequency (HS version 100/sec @ 60hz)
Signal Sensitivity 0.1 uV/graduation (min).
Signal Range 0.5 mV/V - 3.9 mV/V.
Load Cell Excitation 10 VDC.
Load Cell Current 240ma (8, 350 ohm Load Cells).
Auto Zero Tracking 0 to 60 grads, @1/4 grad increments.
Auto Zero Delay 0 to 25 sec, @0.1 sec increments.
Motion Detect 0 to 60 grads, @1/4 grad increments.
Motion Delay 0 to 25 sec, @0.1 sec increments.
Digital Filter 19 settings (0 to 18).
Digital Calibration Front Panel - zero & span stored in EAROM.
Watchdog Timer Fault tolerant operation (212ms).
Power Input 115/220 VAC 50/60 Hz. Only the 115VAC.
Version has been tested to comply with the
Underwriters Laboratories Standards for safety.
Operating Temperature -10 to 40 degrees centigrade.
Options Counting.
Opto-22 relay modules.
12 to 28 volt DC operation.
220 VAC operation.
440HS High speed 100 samples a second.
Analog output module.
To Next Page
Loading...