29
Network Setup
The default setting of the LiteShow box is DHCP client. When the LiteShow module is connected
to a LAN that already has a DHCP server present, the LiteShow module takes an IP address
assigned to it by the server. When the LiteShow module is connected to a LAN that does not have
a DHCP server, the LiteShow module becomes the DHCP server in the network.
IP Setup
You can select “obtain IP address automatically” or “Use the following IP address”:
IP Address: The default value is 192.168.100.10.
Subnet Mask: The default value is 255.255.255.0
Default Gateway: The default value is 192.168.100.10
DNS Server
DHCP Server Setup
Enable or disable the DHCP server automatically, or disable it altogether.
Start IP: The start IP address of DHCP Server.
End IP: The end IP address of DHCP Server.
Subnet Mask
Default Gateway
DNS Server
Wireless Setup
Wireless LAN: “Enable” or “Disable” the Wireless LAN.
Region: Choose your geographic region. “Worldwide” is the default.
SSID: SSID string, maximum length is 32 bytes. (No spaces)
Channel: You can set fixed channel or choose Auto. After powering on the LiteShow,
choosing “Auto” will scan all wireless channels and select one clear channel
automatically.
Encryption: Disable or select a wireless encryption preference (WEP/WPA/WPA2
64-bit or 128-bit in ASCII or HEX string).
Key: If Encryption is enabled, a key value must be set based on the selected
encryption mode.
To Next Page
Loading...
