InFocus LiteShow III - Wireless Client Setup; Connecting as a Wireless Client; Gatekeeper Security Settings

30
Wireless Client Setup
The Wireless Client feature allows LiteShow to connect to the corporate network as a wireless
client rather than through the RJ45 wired connection.
Enable/Disable: To setup LiteShow as a wireless client, choose “Enable.” Note:
Enabling the Wireless Client will disable both the wired RJ45 connection and
Gatekeeper (Gatekeeper will be set to “All Pass”). Disabling the Wireless Client will
restore the RJ45 wired connection.
Existing AP SSID: the SSID string of the corporate wireless LAN (maximum length
32 bytes; no spaces).
Encryption: the encryption method required to access the corporate wireless LAN
(WEP/WPA/WPA2 64-bit or 128-bit in ASCII or HEX string).
Key: the value required to access the corporate wireless LAN. Used only when
Encryption is enabled.
Gatekeeper
Designed to ensure enterprise network security.
All Block: prevents Guest Users connected through a wireless connection from
accessing the office network (LAN).
All Allow: allows Guest Users connected through a wireless connection to access
the office network (LAN).
Internet Only: prevents Guest Users from accessing the office network (LAN), but
still allows internet traffic (browser packets i.e. port 80, 443) to pass through.